Siemens SINUMERIK 802D sl Servisní příručka stáhnout pdf (Strana 54)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

54 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

5.4 Manual machining using cycles (functions)

5.4.1 Principle operating sequence

Functionality

You can perform the following functions manually:

● Drilling centric

● Tapping

● Groove cycles/Parting

● Thread cutting

● Rough turning of contours

When manually machining these functions, the operating sequence is essentially executed in

the same way.

Requirement

The following requirements must be fulfilled before you can execute the functions:

● The spindle is rotating in the correct direction.

Note

Parts can be machined manually only by a spindle started in the correct rotational

direction. An error message is otherwise displayed.

DANGER

Notice: In machining operations, a spindle rotating in the wrong direction can cause

serious damage to the tool, workpiece or machine!

-> Check the direction of rotation of the spindle before pressing NC start!

● Any axis position from which the workpiece position to be machined can be approached

without risk of collision.

● All parameters for the cycles are correctly assigned.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 129 130

Žádné komentáře

Siemens SINUMERIK 802D sl Servisní příručka Strana 54