Siemens SICLOCK GPS1000 Provozní pokyny Strana 38

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 124
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 37
Connection
6-3
© Siemens AG 2010 All Rights Reserved
SICLOCK
®
TC100 Operating Instructions
6.3.1 SICLOCK GPS1000
The GPS receiver GPS1000 is connected according to Figure 6-3.
Figure 6-3 Connection of the radio clock SICLOCK GPS1000 to RADIO CLOCK 1
We recommend using a two-wire, shielded cable, e.g. LiYCY 2x1 mm² as the
radio clock cable. One end of the cable shielding must be connected to a suitable
point at the place of installation.
No further assignment of parameters to the GPS1000 is required.
Functional check
The "RADIO CLOCK" LED on the front panel must flash at about 1Hz when the
GPS1000 is received correctly.
The parameter /Inputs/Input 1/Status (0.20.02)
must change to "GPS" after about
three minutes reception.
/LJKWQLQJSURWHFWLRQ
PD[P
;
5$',2&/2&.%
5$',2&/2&.$
5$',2&/2&.*1'
Warning
Provide lightning protection for the GPS aerial in outdoor areas.
Zobrazit stránku 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 123 124

Komentáře k této Příručce

Žádné komentáře