Siemens CU230P-2 Specifikace stáhnout pdf (Strana 3)

Preposition

Commissioning of the Control Unit CU230P-2 DP with PROFIBUS ID-No: 35934076

Version 1 Issue May 2009 3/33

PDF_Commissioning_of_CU230P_2_DP_with Profibus_en_V1.doc

Preposition

Aim of the application

This application was created in order to provide the user with an easy

introduction to the subject of commissioning the CU230P-2 DP control unit

with PROFIBUS interface.

This application contains general instructions on how to connect the

CU230P-2 DP to a PROFIBUS DP network.

The application describes each of the steps involved in setting up an S7

project to control a SINAMIC G120 with the CU230P-2 DP via PROFIBUS,

and how to control the inverter using a variable table.

Scope

The following core issues are discussed in this application:

• Instructions for connecting the CU230P-2 DP to a PROFIBUS DP

network.

• Commissioning the CU230P-2 DP with PROFIBUS interface

Exclusion

This description can be applied for SINAMICS G120 frequency inverters

with Control Units CU230P-2 DP.

• This application does not include any description of the following

• The SIMATIC STEP 7 programming tool

• The basic commissioning of the frequency inverter

• Commissioning higher-level controls

It is assumed that readers have basic knowledge about these two subjects.

Reference to the Automation and Drives Service & Support

This article is from the Internet Application Portal of the Automation and

Drives Service & Support. You can go directly to the download page of this

document using this link.

http://support.automation.siemens.com/WW/view/en/35934076

1 2 3 4 5 6 7 8 ... 32 33

Žádné komentáře

Siemens CU230P-2 Specifikace Strana 3