Siemens Unix V4.0 Manuál stáhnout pdf (Strana 101)

Configuring Advanced Server for UNIX Configuring NetBIOS

Product Manual U7613-J-Z815-6-76

5.1.2 Configuring Network Interfaces

5.1.2.1 The interfaces.cfg

file

In general every network interface for which TCP/IP is supported can be used by Advanced

Server’s NetBIOS.The file /var/opt/nbrfc/conf/interfaces.cfg is used to describe the network

interfaces to be used by NetBIOS and their properties.

This file is automatically created during NetBIOS installation, if it does not already exist. In

many cases it is not necessary to change this automatically created file. Depending on the

TCP/IP configuration at the creation time of the file there are several sections each

describing a network interface. The syntax of a section is the following:

Syntax of a section in interfaces.cfg:

[<interface_name>]

active=yes | no

used_by_wins=yes | no

ip_addr=default | <ip_address_ddn>

brdcast_addr=default | <brdcast_addr_ddn>

brdcast_list=<brdcast_list>

netmask=default | <netmask_ddn>

Within a section,

<interface_name> is the name (from ifconfig(1M)) of the interface configured by this

section. The name is given inside square brackets.

<ip_address_ddn> is the IP address of the interface given in dotted decimal

notation. (Usually you will use the “default

”

keyword instead.)

<brdcast_addr_ddn> is the broadcast address of the interface given in dotted decimal

notation. (Usually you will use the “default

”

keyword instead.)

<brdcast_list> is an optional (!) comma-separated list of broadcast addresses

given in dotted decimal notation.

<netmask_ddn> is the netmask of the interface given in dotted decimal notation

or as a hex value. (Usually you will use the “default

”

keyword

instead.)

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 365 366

Žádné komentáře

Siemens Unix V4.0 Manuál Strana 101