Siemens Advance Network Gateway Uživatelský manuál stáhnout pdf (Strana 75)

2000591-001 Command Summary •• 69

Command Summary, Continued

This command places a selected port into a hardware diagnostic mode.

The test mode can be used to verify cable continuity and DataNET signal

levels when used in conjunction with an Oscilloscope or other test de-

vice.

The command:

test 1

places port 1 into test mode. The device will generate poll messages on

port 1 every 50 milliseconds. The other port continues to operate nor-

mally. The command:

test off

turns off test mode. Only one port at a time may be in test mode.

This command may be used to disable the user login timeout. Normally,

if a user has not issued a CLI command for five minutes, the device will

automatically shut down the user’s login session. This command may be

used to defeat (and re-enable) this timeout:

timeout off

Disables timeout. The device will not automatically

log out the user, regardless of the time elapsed since

the user last issued a CLI command.

timeout on

Re-enables the five-minute CLI timer.

test

timeout

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 94 95

Žádné komentáře

Siemens Advance Network Gateway Uživatelský manuál Strana 75