Siemens CP 1515 Provozní pokyny Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 274
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Description of the SCALANCE W78x
Operating Instructions SCALANCE W78x
29
eset Button
The reset button is on the rear of the device directly beside the C-PLUG receptacle
and has several functions:
ice.
, press the Reset button.
Loading new firmware
(Only if the normal procedure for loading firmware with Load & Save (see
Section. 6.2.10) does not work). This can, for example, occur if there was a
Follow the steps below to load new firmware:
r to the device.
2. Now press the Reset button and reconnect the power to the device while
ing down the button.
5. Assign an IP address with the Primary Setup Tool.
mmand "ftp <ip address>“ in a DOS box or use a different
der as the
8. For the login and password, enter "siemens“. You can now transfer the new
ware with the "put <firmware>“ command.
Caution:
C79000-G8976-C184-07
R
Restarting the dev
To restart the device
power down during the normal firmware update.
1. Turn off the powe
hold
3. Hold down the button until the red fault LED (F) starts to flash after
approximately 2 seconds.
4. Now release the button. The bootloader waits in this state for a new
firmware
file that you can download by FTP.
6. Connect a PC to the SCALANCE W78x over the Ethernet interface.
7. Then enter the co
FTP client. The new firmware should be located in the same fol
DOS box.
firm
9. Once the firmware has been transferred completely to the device, the device
is restarted automatically.
Restoring the default parameters (factory default)
All previously made settings are lost!
First, turn off the power to the device. Now press the Reset button and
reconnect the power to the device while holding down the button. Hold down
button until the red fault LED (F) stops flashing after approximately 10
the
seconds and is permanently lit. Now release the button and wait until the
fault LED (F) goes off again. The device then starts automatically with the
default parameters.
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 273 274

Komentáře k této Příručce

Žádné komentáře