Siemens SITRANS P Uživatelský manuál stáhnout pdf (Strana 147)

UMSITRPDS3-1 Calibration And Maintenance

November 2010

7-15

MG00353a

Differential Construction

Gauge Construction

Dimension A = 0.1" +/- 0.03 (2.6 mm +/- 0.75)

Enclosure rotation arrow (enclosure rotation reference point)

Ramp-shaped recessed area indicating enclosure rotation range

Enclosure setscrew, use 3/32 (2.5 mm) Allen screw

Tag plate

FIGURE 7-4 Measuring Cell Alignment and Insertion Depth

6. Tighten the enclosure setscrew to 30.1 to 30.9 in lbs (3.4 to 3.6 Nm).

7. Get the electronics module and connect the measuring cell board as described in Section 7.4.2.

8. Install the electronics module as described in Section 7.4.2.

9. Install the display as described in Section 7.4.1.

10. Install the end cap by turning it clockwise until the O-ring contacts the enclosure. Turn the cap one

additional turn to compress the O-ring.

11. Apply power to the transmitter; see Section 3 for wiring diagrams. Refer to the table in Section 7.4

and to Section 6 On-Line Configuration and Operation and configure the transmitter.

12. Reinstall transmitter as described in Section 7.6 Transmitter Replacement.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 221 222

Žádné komentáře

Siemens SITRANS P Uživatelský manuál Strana 147