Siemens IEEE802.11 Provozní pokyny Strana 272

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 292
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 271
Upkeep and maintenance
6.2 Restoring the default parameter settings
SCALANCE W770/W730 to IEEE 802.11n Web Based Management
272 Configuration Manual, 11/2014, C79000-G8976-C323-03
6.2
Restoring the default parameter settings
Procedure
Follow the steps below to reset the device parameters to the factory settings:
Note
When you reset the device parameters
, all previously changed settings are lost!
1. Turn off the power to the device.
2. Now press the Reset button and reconnect the power to the device while holding down
the button.
3. Hold down the button until the red fault LED (F) stops flashing after approximately 10
seconds and is permanently lit.
4. Now release the button and wait until the fault LED (F) goes off again.
5. The device then starts automatically with the default parameters.
Zobrazit stránku 271
1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 291 292

Komentáře k této Příručce

Žádné komentáře