Siemens SINUMERIK 802D sl Servisní příručka stáhnout pdf (Strana 112)

Machining the machining step program manually

6.1 Tool change in the machining step program

Manual Machine Plus Turning

112 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

3. To select the tool, enter the tool number and the cutting edge number in the input fields

"T" and "D", respectively.

- OR -

Use the <Tab key> to change to the list and position the cursor on the appropriate tool

and press the <INPUT> key to confirm the selection.

The selected tool is copied into the "T" input field.

4. If the tick is set in the field "G75" (approach fixed point), the controller travels to a stored

fixed point before the tool change.

5. Press "OK".

Figure 6-7 Tool change in the machining step program, first prompt

With this prompt, you decide whether the tool should be used in all subsequent steps up

to the next tool change.

6. The following options are available:

;

$ERUW

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 129 130

Žádné komentáře

Siemens SINUMERIK 802D sl Servisní příručka Strana 112