Siemens SINUMERIK 802D sl Servisní příručka stáhnout pdf (Strana 27)

Setting-up

4.2 Limit stops

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Parameter

Parameter Description

ON The limit stop is activated.

OFF The limit stop is deactivated.

- X Negative absolute position of the limit stop of the X axis.

The axis stops automatically if:

• The limit stop is active.

• The specified axis traverses in the negative direction and reaches the absolute limit stop position.

+X Positive absolute position of the limit stop of the X axis.

The axis stops automatically if:

• The limit stop is active.

• The specified axis traverses in the positive direction and reaches the absolute limit stop position.

-Z Negative absolute position of the limit stop of the Z axis.

The axis stops automatically if:

• The limit stop is active.

• The specified axis traverses in the negative direction and reaches the absolute limit stop position.

+Z Positive absolute position of the limit stop of the Z axis.

The axis stops automatically if:

• The limit stop is active.

• The specified axis traverses in the positive direction and reaches the absolute limit stop position.

All of the limit stops are set in the following screen.

Figure 4-4 All limit stops set

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 129 130

Žádné komentáře

Siemens SINUMERIK 802D sl Servisní příručka Strana 27