Siemens SINUMERIK 802D sl Servisní příručka stáhnout pdf (Strana 32)

Setting-up

4.3 Setting the workpiece zero

Manual Machine Plus Turning

32 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Operating sequences

Press the "Set WO" softkey in the main screen for "Manual Machine Plus".

Figure 4-5 Set workpiece zero point

This screen displays the currently programmed Z value of the basic work offset.

The setting options in this screen are selected with softkeys. The softkey meanings are as

follows:

This function is used to set the “workpiece zero”.

The workpiece coordinate system of the longitudinal axis (Z) displays the value "0.000".

The required work offset is computed automatically and stored in the appropriate place in the

NC.

This function resets the work offset that is currently stored on the NC. -> The value “0.000” is

entered in the basic offset memory location. However, all other offsets and the active tool

offset remain unchanged.

6HW

= 

'HOHWH

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 129 130

Žádné komentáře

Siemens SINUMERIK 802D sl Servisní příručka Strana 32