Siemens SINUMERIK 802D sl Servisní příručka stáhnout pdf (Strana 71)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Multiple tapping

DANGER

Notice: When multiple parting is selected, make sure that there is sufficient clearance from

the spindle as measured from starting position "Reference z0" to allow all parameterized

parting operations to be performed. There is otherwise a risk of collision between the tool

and the chuck!

-> Check the plausibility of the input values before pressing NC start!

The machining sequence is as follows:

1. Machining takes place in the same way as for machining of "multiple grooves". The only

difference lies in the fact that this is a "parting" rather than a "grooving" operation.

2. Finally, the original position of the axes before the start of machining is approached

diagonally.

5.4.5.5 Extended grooving

Operating sequences

You can access the grooving cycle overview by pressing the softkey "Grooving" in the basic

screen for "Manual Machine Plus".

Figure 5-30 Grooving cycle overview - "Extended groove" selected

*URRYH

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 129 130

Žádné komentáře

Siemens SINUMERIK 802D sl Servisní příručka Strana 71