
MODEL DESIGNATION AND SPECIFICATIONS UM344-2
September 1995
8.3.6.1 CSA Hazardous Locations Precautions
This section provides CSA hazardous location precautions that should be observed by the user when
installing or servicing the equipment described in this Instruction. These statements supplement those
given in the preceding section.
WARNING
Failure to observe the following precautions could result in an explosion
hazard.
Precautions - English
For Class I, Division 1 and Class I, Division 2 hazardous locations,
Ÿ Use only factory-authorized replacement parts. Substitution of components can impair the suitability
of this equipment for hazardous locations.
For Division 2 hazardous locations:
When the equipment described in this Instruction in installed without safety barriers, the following
precautions should be observed. Switch off electrical power at its source (in non-hazardous location)
before connecting or disconnecting power, signal, or other wiring.
Précautions - Français
Emplacements dangereux de classe I, division 1 et classe I, division 2:
Ÿ Les pièces de rechange doivent être autorisées par l'usine. Les substitutions peuvent rendre cet
appareil impropre à l'utilisation dans les emplacements dangereux.
Emplacement dangereux de division 2:
Lorsque l'appareil décrit dans la notice ci-jointe est installé sans barrières de sécurité, on doit couper
l'alimentation électrique a la source (hors de l'emplacement dangereux) avant d'effectuer les opérations
suivantes branchment ou débranchement d'un circuit de puissance, de signalisation ou autre.
Komentáře k této Příručce