Siemens Pacemaker UM344-2 Uživatelský manuál stáhnout pdf (Strana 55)

UM344-2 INSTALLATION

September 1995

2. Bracket to Pipe Mounting

1) At the selected location on the pipe, place the pipe-groove side of the mounting bracket against the

pipe. See Figure 4-6.

2) Slip the supplied U-bolt around the pipe and through one of the two pairs of mounting holes in the

pipe-groove face plate of the bracket.

3) Place a supplied washer and hex nut on each end of the U-bolt and hand tighten the nuts. Rotate

the bracket around the pipe to place the Transmitter in the desired position, then secure the

bracket to the pipe.

3. Reposition the Transmitter's local display (if any) to provide the best possible view of the display.

Refer to Section 4.4.4.

4.4.2 Flat Surface Mounting

A Transmitter can be mounted to a flat surface using the supplied mounting bracket and user supplied

5/16-inch bolts.

Refer to Figures 4-5 and 4-6 and the following for mounting guidance:

1. Bracket To Flat Surface Mounting

1) Refer to Figure 4-5 for the bracket mounting hole dimensions.

2) Layout the mounting hole pattern on the selected area of the surface. Drill 0.344-inch diameter

mounting holes to accept 5/16-inch bolts.

The thickness of the mounting surface and bracket height above the surface are factors in

determining the required length of the mounting bolts.

3) Place the pipe-groove side of the bracket against the mounting surface site and align the bracket

and surface mounting holes. Install the bracket with user supplied 5/16-inch bolts, washers, and

hex nuts.

2. Transmitter To Bracket Mounting

1) Mount transmitter to bracket as described in Section 4.4.1, step 1.

2) Reposition the Transmitter's local display (if any) to provide the best possible view of the display.

Refer to Section 4.4.4.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 182 183

Žádné komentáře

Siemens Pacemaker UM344-2 Uživatelský manuál Strana 55