Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 100)

Overview of alarms 06/2009

NCK alarms

2-100

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

14099 [Channel %1: ] Block %2 result in string concatenation too long

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The result of string chaining returns a string which is greater than the maximum string length laid down

by the system.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adapt part program. With the function STRLEN, it is also possible to query the size of the sum string

before executing the chaining operation.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14130 [Channel %1: ] Block %2 too many initialization values given

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: On assigning an array by means of SET, more initialization values than existing array elements have

been specified in the program run.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce the number of initialization values.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14160 [Channel %1: ] Block %2 tool length selection without geometry axis

specification

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If variant C (tool length acts on the programmed axis) is activated by machine data MD20380

$MC_TOOL_CORR_MODE_G43G44 for tool length compensation with H word and G43/G44 in

ISO_2 mode, at least one geometry axis must be specified.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change MD20380 $MC_TOOL_CORR_MODE_G43G44 or the part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14165 [Channel %1: ] Block %2 selected ISO H/D number %3 does not match

tool %4

Parameters: %1 = Channel number

%2 = Block number, label

%3 = ISO H/D number

%4 = Tool number

Definitions: When an H or D number is programmed in ISO_2 or ISO_3 mode, it must be available in the active

tool. The active tool may also be the last tool loaded on the master spindle or master toolholder. This

alarm is output if there is no H or D number on this tool.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Set ISO H/D number correctly.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 100

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl