Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 190)

Overview of alarms 06/2009

NCK alarms

2-190

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

26100 Axis %1 drive %2 sign of life missing

Parameters: %1 = Axis name, spindle number

%2 = Drive number

Definitions: Special case: The output of drive number=0 indicates that a computing timeout occurred on the IPO

level (see also alarm 4240)

Reaction: NC not ready.

The NC switches to follow-up mode.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Restart drive, check drive software.

Program Con-

tinuation:

Switch control OFF - ON.

26101 Axis %1 drive %2 communication failure

Parameters: %1 = Axis name, spindle number

%2 = Drive number

Definitions: For PROFIdrive only:

The drive is not communicating.

Reaction: Mode group not ready.

The NC switches to follow-up mode.

Channel not ready.

NC Start disable in this channel.

Axes of this channel must be re-referenced.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: - Check the bus configuration.

- Check the interface (connector removed, option module inactive, etc.).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

26102 Axis %1 drive %2 sign of life missing

Parameters: %1 = Axis name, spindle number

%2 = Drive number

Definitions: For PROFIdrive only:

The sign-of-life cell is no longer being updated by the drive.

Reaction: Mode group not ready.

The NC switches to follow-up mode.

Channel not ready.

NC Start disable in this channel.

Axes of this channel must be re-referenced.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: - Check the cycle settings.

- Increase the cycle time if necessary.

- Power-up the drive again.

- Check drive software.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 190

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl