Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 114)

Overview of alarms 06/2009

NCK alarms

2-114

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Modify part program, retrofit option.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14782 [Channel %1: ] Block %2 non-active function used (identification %3)

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Fine ID

Definitions: A non-active function is used in the block

Brief description of the identification

1 Transformation

2 H number of the tool

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: - Modify part program.

- Activate function.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14790 [Channel %1: ] Block %2 axis %3 programmed by PLC

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis

Definitions: In the NC block, an axis has been programmed that is already being traversed by the PLC.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: - Modify part program, do not use this axis.

- Stop traversing motion of the axis by the PLC, modify part program (insert WAITP).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14800 [Channel %1: ] Block %2 programmed path speed less or equal to zero

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Zero or a negative F or FZ value has been programmed in conjunction with the G functions G93, G94,

G95 or G96. The path velocity may be programmed in the range of 0.001 to 999 999.999 [mm/min,

mm/rev, mm/tooth, deg/min, deg/rev] for the metric input system and 0.000 1 to 39 999.999 9

[inch/min, inch/rev, inch/tooth] for the inch input system.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program the path velocity (geometric sum of the velocity components of the geometry axes involved)

within the limits given above.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14810 [Channel %1: ] Block %2 negative axis speed programmed for

positioning axis %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis

Definitions: A negative feed (FA value) has been programmed for the displayed axis presently operating as a posi-

tioning axis. The positioning velocity may be programmed in the range 0.001 to 999 999.999 [mm/min,

deg/min] for the metric input system and 0.000 1 to 39 999.999 9 [inch/min, inch/rev] for the inch input

system.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 114

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl