Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 151)

NCK alarms

06/2009 Overview of alarms

2-151

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Modify MD10930 $MN_INDEX_AX_POS_TAB_2 [n]

(Positions of the 1st indexing axis) The absolute axis positions are entered. (The list length is defined

via MD10900 $MN_INDEX_AX_LENGTH_POS_TAB_1).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17600 [Channel %1: ] Block %2 preset on transformed axis %3 not possible

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: The programmed PRESET axis is involved in the current transformation. This means that setting the

actual value memory (PRESET) is not possible for this axis.

Example:

Machine axis A should be set to the new actual value A 100 at the absolute position A 300.

N100 G90 G00 A=300

N101 PRESETON A=100

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Avoid preset actual value memory for axes which are participating in a transformation or deselect the

transformation with the keyword TRAFOOF.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17610 [Channel %1: ] Block %2 axis %3 involved in the transformation, action

cannot be carried out

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: The axis is involved in the active transformation. It can therefore not execute the demanded action,

traversing as positioning axis, enable for axis exchange.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Deselect the transformation with TRAFOOF ahead of time or remove the action from the part program

block

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17620 [Channel %1: ] Block %2 approaching fixed point for transformed axis

%3 not possible

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: In the displayed block, an axis is programmed for the fixed point approach (G75) that is involved in the

active transformation. Fixed point approach is not performed with this axis!

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove G75 instruction from the part program block or previously deselect transformation with TRA-

FOOF.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17630 [Channel %1: ] Block %2 referencing for transformed axis %3 not

possible

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 151

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl