Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 202)

Overview of alarms 06/2009

Cycle alarms

2-202

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Interface signals are set.

Alarm display.

Remedy: Check parameter _LP1 or _LP2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61117 [Channel %1: ] Block %2: Active tool radius <= 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The radius of the acive tool is negative or zero. Alarm triggered by following cycles: CYCLE71,

POCKET3, POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61118 [Channel %1: ] Block %2: Length or width = 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The length or width of the milling area is illegal. Alarm triggered by following cycle: CYCLE71.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameters _LENG and _WID.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61119 [Channel %1: ] Block %2: Nominal or core diameter programmed

incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The nominal or core diameter was incorrectly programmed. Alarm triggered by following cycles:

CYCLE70, E_MI_TR, F_MI_TR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61120 [Channel %1: ] Block %2: Thread type inside / outside not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The thread type (internal/external) was not defined. Alarm triggered by following cycles: CYCLE70.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The internal/external thread type must be entered.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 202

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl