Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 193)

2-193

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

2.2 Cycle alarms

61000 [Channel %1: ] Block %2: No tool offset active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: LONGHOLE, SLOT1, SLOT2, POCKET1 through POCKET4,

CYCLE71, CYCLE72, CYCLE90, CYCLE93 through CYCLE96.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: D-correction must be programmed prior to cycle call.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61001 [Channel %1: ] Block %2: Thread pitch incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840, CYCLE96, CYCLE97.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter for the thread size or setting for the pitch (contradict each other).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61002 [Channel %1: ] Block %2: Type of machining incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The value of the VARI parameter for the machining has been incorrectly specified. Alarm triggered by

following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71, CYCLE72, CYCLE76,

CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98.

Remedy: Modify VARI parameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61003 [Channel %1: ] Block %2: No feed programmed in cycle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameter for the feed has been incorrectly specified. Alarm triggered by following cycles:

CYCLE71, CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify feed parameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 193

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl