Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 219)

Cycle alarms

06/2009 Overview of alarms

2-219

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up screen form

"Rotary axes" to "Automatic".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61233 [Channel %1: ] Block %2: Thread angle wrongly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The thread angles were specified too large or too small.

Alarm triggered by following cycles: E_TR_CON, F_TR_CON

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61237 [Channel %1: ] Block %2: Retraction direction unknown. Withdraw tool

manually!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool is in the retraction area and it is unknown in which direction it can be travelled out of it.

Alarm triggered by following cycle: F_SP_RP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Manually retract the tool from the retraction area defined in the program header and restart the pro-

gram.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61238 [Channel %1: ] Block %2: Machining direction unknown!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The direction of the next machining is unknown.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please contact the responsible Siemens regional office.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61239 [Channel %1: ] Block %2: Tool change point lies within retraction area!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool change point has to be far enough outside the retraction area so that when the revolver is

swiveled, no tool extends into the retraction area.

The alarm is triggered by the following cycle: F_SP_RP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify another tool change point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 219

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl