Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 38)

Overview of alarms 06/2009

NCK alarms

2-38

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: The NC card cannot be accessed because a valid write algorithm is not available for the flash memory.

Reaction: Alarm display.

Remedy: Use a compatible NC card or enter the new manufacturer code/device code in MD11700

$MN_PERMISSIVE_FLASH_TAB after consultation with SIEMENS.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

7500 Block %1 invalid protection level for command %2 (protection level act.:

%3 prog.: %4)

Parameters: %1 = Block number

%2 = Programmed command

%3 = Current protection level of the command

%4 = Programmed protection level of the command

Definitions: On assigning a protection level for a parts program command via REDEF command

- an impermissible parts program command has been programmed

- a protection level has been programmed that is logically smaller (larger in value) than the protection

level currently applicable for this command.

- the relevant definition file has not been protected sufficently against write access. The write protec-

tion of the file must be at least as high as the highest protection level that has been assigned to a parts

program command in this definition file.

Reaction: Alarm display.

Remedy: Modify definition files /_N_DEF_DIR/_N_MACCESS_DEF or /_N_DEF_DIR/_N_UACCESS_DEF-

CESS_ DEF. Please see the Siemens Programming Guide or the OEM documentation for the lan-

guage commands permissible for the relevant system configurations.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

8000 [Channel %1: ] Option 'Interrupt routines' not set

Parameters: %1 = Channel number

Definitions: Fast NCK inputs are required for the input signals in order to activate the interrupt routines and rapid

lift from contour. This function is not included in the basic version and must be retrofitted when needed.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Do not use rapid interrupt inputs or con-

tact the machine manufacturer with a view to retrofitting this option!

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

8010 Option 'activation of more than %1 axes' not set

Parameters: %1 = Number of axes

Definitions: More machine axes have been defined through the MD20070 $MC_AXCONF_MACHAX_USED than

are allowed in the system.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. The sum of all axes that have been con-

figured through the channel-specific MD20070 $MC_AXCONF_MACHAX_USED, must not exceed

the maximum number of axes (dependent on configuration -> option, basic version: 4 axes).

Program Con-

tinuation:

Switch control OFF - ON.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 38

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl