Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 237)

Cycle alarms

06/2009 Overview of alarms

2-237

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61347 [Channel %1: ] Block %2: Angle 1st edge - 2nd edge equals 0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE961.

Remedy: Parameter _INCA equals 0.

61348 [Channel %1: ] Block %2: Angle rel. to reference edge equals 0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61349 [Channel %1: ] Block %2: Distance upper probe edge - measuring

position = 0 for tool radius measurement

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE971.

Parameter _TP[x,9] distance between upper edge and lower edge of tool probe equals 0; relevant for

radius measurement.

Remedy: Check parameter _TP[x,9].

61350 [Channel %1: ] Block %2: feed, speed not programmed in _MFS for tool

measurement with rotating spindle

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE971.

Measuring feed and/or spindle speed of tool measurement with rotating spindle in GUD variable

_MFS[2] not specified.

Remedy: Check parameter _MFS[2].

61351 [Channel %1: ] Block %2: Tool length or radius is 0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE971.

For the active tool, the length or radius equal zero.

Remedy: Check length and radius of the active tool in the compensation data memory.

61352 [Channel %1: ] Block %2: Path for logfile not permitted

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE106.

The specified path for the log file is incorrect.

Remedy: Check parameter _PROTNAME[1].

61353 [Channel %1: ] Block %2: Path for logfile not found

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE106.

The specified directory does not exist or the specified path is incorrect.

Remedy: Check parameter _PROTNAME[1].

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 237

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl