Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 28)

Overview of alarms 06/2009

NCK alarms

2-28

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Switch control OFF - ON.

4300 Declaration in MD %1 is not allowed for axis %2.

Parameters: %1 = String: MD identifier

%2 = Axis name, spindle number

Definitions: The axis cannot be operated as competing positioning axes,

for example because the axis is the slave axis within a closed gantry group or a gantry group to be

closed.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department. Reset MD30450

$MA_IS_CONCURRENT_POS_AX for the axis concerned.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4310 Declaration in MD %1 index %2 is not allowed.

Parameters: %1 = String: MD identifier

%2 = Index: MD array index

Definitions: The machine data values must be written in the array in ascending order.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Correct the MD.

Program Con-

tinuation:

Clear alarm with the RESET key in all channels of this mode group. Restart part program.

4320 Axis %1 function %2 %3 and %4 not allowed

Parameters: %1 = String: Axis identifier

%2 = String: MD identifier

%3 = String: Bit

%4 = String: MD identifier

Definitions: The functions declared by the specified machine data cannot simultaneously be active for one axis.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Deactivate one of the functions.

Program Con-

tinuation:

Switch control OFF - ON.

4340 [Channel %1: ] Block %2 invalid transformation type in transformation

no. %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Transformation number

Definitions: An invalid, i.e. undefined, number was entered in one of the machine data TRAFO_TYPE_1 ...

TRAFO_TYPE_8. This alarm also occurs if a certain type of transformation is only impossible on the

type of control used (e.g. 5-axis transformation on a SINUMERIK 802D sl).

Reaction: Correction block is reorganized.802D sl

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Enter a valid transformation type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 28

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl