Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 233)

Cycle alarms

06/2009 Overview of alarms

2-233

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

and adjust _CVAL[0]/_CVAL[1] accordingly.

61314 [Channel %1: ] Block %2: Check selected tool type

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm is triggered: CYCLE971, CYCLE972, CYCLE982.

Remedy: Tool type impermissible for tool measurement/tool probe calibration.

61315 [Channel %1: ] Block %2: Check position of cutting edge

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm is triggered: CYCLE972, CYCLE973, CYCLE974, CYCLE982, CYCLE994.

Remedy: Check tool edge position (probe) in TO memory.

61316 [Channel %1: ] Block %2: Center and radius cannot be determined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No circle can be calculated from the measured points, as all measured points lie on a straight line.

The alarm is triggered by: CYCLE979

Remedy: Program change

61317 [Channel %1: ] Block %2: Check parameter CYCLE116

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Parameterization faulty; requires 3 or 4 points to calculate the center point. Alarm is triggered:

CYCLE979.

Remedy: Change parameterization of CYCLE116.

61318 [Channel %1: ] Block %2: Check weighting factor _K

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Parameter _K is 0. Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994,

CYCLE998.

Remedy: Check parameter _K.

61319 [Channel %1: ] Block %2: Check call parameter CYCLE114

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Internal error in measuring cycles. Alarm is triggered: CYCLE974, CYCLE977, CYCLE978,

CYCLE979, CYCLE994, CYCLE998.

Remedy: Check call parameter CYCLE114.

61320 [Channel %1: ] Block %2: Check tool number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With active tool management, parameter _TNUM=0 and parameter _TNAME is not set or

the specified tool name of tool management is unknown.

The alarm can be triggered by the following measuring cycles: all measuring cycles.

Remedy: Check parameter _TNUM, _TNAME.

61321 [Channel %1: ] Block %2: Check WO memory number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: WO with the number specified in _KNUM not existing. Alarm is triggered: CYCLE974, CYCLE977,

CYCLE978, CYCLE979, CYCLE994, CYCLE998.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _KNUM.

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 233

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl