Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 109)

NCK alarms

06/2009 Overview of alarms

2-109

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: Check the variable types in the EXTERN and the PROC statements for correspondence and correct-

ness.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14600 [Channel %1: ] Block %2 reload buffer %3 cannot be established

Parameters: %1 = Channel number

%2 = Block number, label

%3 = File name

Definitions: The download buffer for "execute from external" could not be created. Possible causes:

- Not enough memory available (for minimum see MD18360 $MN_MM_EXT_PROG_BUFFER_SIZE)

- No resources available for HMI NCK communication (see MD18362 $MN_MM_EXT_PROG_NUM)

- The file already exists

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - Release memory, e.g. by deleting part programs

- Modify MD18360 $MN_MM_EXT_PROG_BUFFER_SIZE and/or MD18362

$MN_MM_EXT_PROG_NUM.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14601 [Channel %1: ] Block %2 reload buffer could not be deleted

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The reload buffer for "execute from external" could not be deleted. Possible cause:

- HMI/PLC communication was not terminated.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: All reload buffers are cleared on POWER ON.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14602 [Channel %1: ] Block %2 timeout while reloading from external.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No connection could be made to the HMI while reloading external subprograms (EXTCALL) or exe-

cuting from external drives) within the monitoring time set in MD10132 $MN_MMC_CMD_TIMEOUT.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - Check the connection to the HMI

- Increase MD10132 $MN_MMC_CMD_TIMEOUT.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14610 [Channel %1: ] Block %2 compensation block not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An alarm was output which could be eliminated basically via program correction. Since the error

occurred in a program which is processed from external, a compensation block/program correction is

not possible.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 109

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl