Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 236)

Overview of alarms 06/2009

Cycle alarms

2-236

© Siemens AG 2009 All Rights Reserved

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Check parameter _SPEED[1], _SPEED[2] in GUD6.

61339 [Channel %1: ] Block %2:Correction factor for rapid traverse speed = 0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Check parameter _SPEED[0] in GUD6.

61340 [Channel %1: ] Block %2: Incorrect alarm number

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Internal error in measuring cycles.

61341 [Channel %1: ] Block %2: Probe not calibrated in active plane.

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE974, CYCLE977, CYCLE978, CYCLE979.

Remedy: Calibrate the probe prior to calling a cycle.

61342 [Channel %1: ] Block %2: Invalid software version or wrong format

entered in GUD6

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Lower than measuring cycle software 6.2:_SI[1] in GUD6 has no value or a value < 3

Higher than measuring cycle software 6.3: Upgrade NCK software version.

61343 [Channel %1: ] Block %2: No tool available for specified tool identifier

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Check name of tool identifier.

61344 [Channel %1: ] Block %2: Several tools are active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Remove tool from another spindle.

61345 [Channel %1: ] Block %2: Parameterized D number (_KNUM) too large

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Reduce the D number in _KNUM, check software or MD of flat D number.

61346 [Channel %1: ] Block %2: Distance starting point/measuring point

_SETV[0] and _SETV[1] <=0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE961.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Parameters _SETV[0] or _SETV[1] are empty or smaller than 0.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 339 340

Komentáře k této Příručce

Žádné komentáře