Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 214)

Overview of alarms 06/2009

Cycle alarms

2-214

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: Program a technology block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61203 [Channel %1: ] Block %2: No position cycle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No positioning cycle was programmed in the machining block.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program positioning block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61204 [Channel %1: ] Block %2: Technology cycle unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified technology cycle in the machining block is unknown.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete and reprogram the technology block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61205 [Channel %1: ] Block %2: Position cycle unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified positioning cycle in the machining block is unknown.

Alarm triggered by following cycles: E_MANAGE, F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete and reprogram the positioning block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61210 [Channel %1: ] Block %2: Block search element not found

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The element specified for the block search does not exisit.

Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL, E_PS_SEQ,

E_PS_XYA, F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Repeat block search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 214

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl