Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 18)

Overview of alarms 06/2009

NCK alarms

2-18

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Check axis configuration and enter the missing identifier into the MD or, should the axis not exist,

specify for this channel axis the machine axis 0 in the channel-specific MD20070

$MC_AXCONF_MACHAX_USED. If this concerns a geometry axis that is not to be used (this applies

only for 2-axis machining, e.g. on lathes), then channel axis 0 must be entered additionally in the chan-

nel-specific MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB.

Program Con-

tinuation:

Switch control OFF - ON.

4032 [Channel %1: ] Wrong identifier for facing axis in %2

Parameters: %1 = Channel number

%2 = String: MD identifier

Definitions: According to the axis configuration in MD20150 $MC_GCODE_RESET_VALUES or MD20100

$MC_DIAMETER_AX_DEF, a facing axis identifier is expected at the specified location.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Add the correct identifier.

Program Con-

tinuation:

Switch control OFF - ON.

4040 [Channel %1: ] Axis identifier %2 not consistent with machine data %3

Parameters: %1 = Channel number

%2 = String: Axis identifier

%3 = String: MD identifier

%4 = There are not enough channel axes entered in the MD displayed.

Definitions: The use of the specified axis identifier in the displayed MD is not consistent the channel's axis config-

uration stated in the MD20070 $MC_AXCONF_MACHAX_USED and MD20050

$MC_AXCONF_GEOAX_ASSIGN_TAB.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

Check and correct the identifier used in the MD10000 $MN_AXCONF_MACHAX_NAME_TAB,

MD20080 $MC_AXCONF_CHANAX_NAME_TAB and/or MD20060

$MC_AXCONF_GEOAX_NAME_TAB.

Program Con-

tinuation:

Switch control OFF - ON.

4045 [Channel %1: ] Conflict between machine data %2 and machine data %3

Parameters: %1 = Channel number

%2 = String: MD identifier

%3 = String: MD identifier

Definitions: Using the specified machine data %1 leads to a conflict with machine data %2.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Correct the specified machine data.

Program Con-

tinuation:

Switch control OFF - ON.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl