Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 44)

Overview of alarms 06/2009

NCK alarms

2-44

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

%4 = The axis of the software limit switch is only output if different from the traversing axis.

Definitions: The specified axis is already positioned at the displayed software end delimiter.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department. Check machine data MD36110

$MA_POS_LIMIT_PLUS/MD36130 $MA_POS_LIMIT_PLUS2 and MD36100

$MA_POS_LIMIT_MINUS/MD36120 $MA_POS_LIMIT_MINUS2 for the software limit switches.

Shut down in JOG mode from the software limit switch.

Please inform the authorized personnel/service department.

Machine data:

Check whether the 2nd software limit switch has been selected in the.axis-specific interface signals:

"V380x 1000.3 (2nd software limit switch plus) and V380x 1000.2 (2nd software limit switch minus).

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

10630 [Channel %1: ] Block %2 axis %3 at working area limit %4

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis, spindle number

%4 = String (+ or -)

Definitions: The specified axis violates the working area limitation. This is recognized only in the main run either

because the minimum axis values could not be measured before the transformation or because there

is a motion overlay.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Program other motion or do not perform overlaid motion.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10631 [Channel %1: ] Axis %2 rests at working area limit %3%4

Parameters: %1 = Channel number

%2 = Axis, spindle

%3 = String (+ or -)

%4 = The axis of the working area limitation is only output if different from the traversing axis.

Definitions: The specified axis reaches the working area limitation in JOG mode.

Reaction: Alarm display.

Remedy: Check SD43420 $SA_WORKAREA_LIMIT_PLUS and SD43430 $SA_WORKAREA_LIMIT_MINUS

for the working area limitation.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

10650 [Channel %1: ] Axis %2 incorrect gantry machine data, error code %3

Parameters: %1 = Channel number

%2 = Axis

%3 = Error no.

Definitions: An incorrect value was entered in the gantry-specific axial machine data. Further information can be

derived from the error number.

- Error no. = 1 => either an incorrect gantry unit has been entered or the designation of the following

axis is incorrect.

- Error no. = 2 => master axis has been specified more than once.

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl