Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 154)

Overview of alarms 06/2009

NCK alarms

2-154

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Please inform the authorized personnel/service department. Modify program or set MD18600

$MN_MM_FRAME_FINE_TRANS to 1.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

18310 [Channel %1: ] Block %2 frame: illegal rotation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Rotations are not possible with NCU global frames.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18311 [Channel %1: ] Block %2 frame: illegal instruction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to read or write a frame which does not exist.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18313 [Channel %1: ] Block %2 frame: illegal switchover of geometry axes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not allowed to change the geometry axis assignment because the current frame contains rota-

tions.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Change NC program or set other mode with MD10602 $MN_FRAME_GEOAX_CHANGE_MODE.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18314 [Channel %1: ] Block %2 frame: type conflict

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not possible to chain global frames and channel-specific frames. The alarm occurs if a global

frame is programmed with a channel axis name and no machine axis on this NCU is assigned to the

channel axis. Channel-specific frames cannot be programmed with machine axis names if there is no

corresponding channel axis on this NCU.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 154

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl