Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 128)

Overview of alarms 06/2009

NCK alarms

2-128

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: No pitch was programmed in a thread block with G33 (thread with constant pitch) or G331 (rigid tap-

ping).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: The thread pitch must be programmed for the specified geometry axis under the associated interpo-

lation parameters.

X -> I

Y -> J

Z -> K

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16730 [Channel %1: ] Block %2 axis %3 wrong parameter

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: In G33 (tapping with constant pitch) the pitch parameter was not assigned to the axis that determines

the velocity.

For longitudinal and face threads, the thread pitch for the specified geometry axis must be pro-

grammed under the associated interpolation parameter.

X -> I

Y -> J

Z -> K

For taper threads, the address I, J, K depends on the axis with the longer path (thread length). A 2nd

lead for the other axis is, however, not specified.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Assign lead parameters to the axis that determines the velocity.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16740 [Channel %1: ] Block %2 no geometry axis programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No geometry axis was programmed for tapping (G33) or for rigid tapping (G331, G332). The geometry

axis is, however, essential if an interpolation parameter has been specified.

Example:

N100 G33 Z400 K2 ; thread pitch 2mm, thread end Z=400 mm

N200 SPOS=0 ; position spindle in axis mode

N201 G90 G331 Z-50 K-2 ; tapping to Z=-50, counterclockwise

N202 G332 Z5 ; retraction, direction reversal automatic

N203 S500 M03 ; spindle again in spindle mode

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Specify geometry axis and corresponding interpolation parameters.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16750 [Channel %1: ] Block %2 axis %3 SPCON not programmed

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: For the programmed function (rotary axis, positioning axis), the spindle must be in position control

mode.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program position control of the spindle with SPCON in the previous block.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 128

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl