Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 228)

Overview of alarms 06/2009

Cycle alarms

2-228

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm triggered by following cycle: E_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another retraction plane or approach a suitable interpolation point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61276 [Channel %1: ] Block %2: External tool diameter required for restrictions

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Outer tool diameter required in case of delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify the outer tool diameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61277 [Channel %1: ] Block %2: Tool diameter larger than restriction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Tool diameter larger than delimitation.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a smaller tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61278 [Channel %1: ] Block %2: If tool angle is larger than 90°, both tool

diameters must be equal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For tool angles larger than 90°, the two tool diameters must be identical.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the tool angle or the tool diameters.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61279 [Channel %1: ] Block %2: If tool angle equals 90°, both tool diameters

must be equal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For tool angles equal to 90°, the two tool diameters must be identical.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the tool angle or the tool diameters.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 228

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl