Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 50)

Overview of alarms 06/2009

NCK alarms

2-50

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10743 [Channel %1: ] Block %2 WAB programmed several times

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt has been made to activate a WAB motion before a previously activated WAB motion was

terminated.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10744 [Channel %1: ] Block %2 no valid WAB direction defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tangent direction for smooth approach or retraction is not defined.

Possible causes:

In the program, no block with travel information follows the approach block.

Before a retraction block, no block with travel information has been programmed in a program.

The tangent to be used for WAB motion is vertical to the current machining plane.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10745 [Channel %1: ] Block %2 WAB end position not clear

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the WAB block and in the following block, the position has been programmed perpendicular to the

machining direction. In the WAB block, no position has been indicated in the machining plane.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program. Either remove the position data for the infeed axis from the WAB block or the

following block, or program a position in the machining plane in the WAB block as well.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10746 [Channel %1: ] Block %2 block search stop for WAB

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A preprocessing stop has been inserted between an SAR approach block and the following block

defining the tangent direction or between an SAR retraction block and the following block defining the

end position.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 50

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl