Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 250)

Overview of alarms 06/2009

Cycle alarms

2-250

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61540 [Channel %1: ] Block %2: Incorrect D number / dresser D field active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE401, CYCLE402, CYCLE403,

CYCLE443

Remedy: A tool D number must be programmed that is < _GC_DNUM

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61541 [Channel %1: ] Block %2: Incorrect grinding wheel type entered

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE432, CYCLE434, CYCLE435,

CYCLE436, CYCLE438, CYCLE439, CYCLE444, CYCLE447

Remedy: Select a valid grinding wheel type in tool management

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61542 [Channel %1: ] Block %2: Incorrect grinding wheel reference point

selected when selecting the dresser coordinate system

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE435, CYCLE441, CYCLE447

Remedy: A tool D number must be programmed that is < _GC_DNUM

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61543 [Channel %1: ] Block %2: Incorrect dresser selected when selecting the

dresser coordinate system

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE402, CYCLE435, CYCLE442,

CYCLE447

Remedy: A dresser number >0 and <4 must be selected

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61544 [Channel %1: ] Block %2: Grinding wheel diameter worn down

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE438

Remedy: New grinding wheel required, or check limit values in the grinding wheel data

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61545 [Channel %1: ] Block %2: Width of grinding wheel worn down

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE438

Remedy: New grinding wheel required, or check limit values in the grinding wheel data

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61546 [Channel %1: ] Block %2: Dresser %4, wear limit length 1 reached

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE438

Remedy: New dresser required, or check limit values of dresser

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 250

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl