Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 40)

Overview of alarms 06/2009

NCK alarms

2-40

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Switch control OFF - ON.

8080 %1 option(s) is/are activated without setting the license key

Parameters: %1 = Number of non-licensed options

Definitions: One or more options were activated but no license key was set to prove the purchase of the option(s).

Reaction: Alarm display.

Remedy: Generate license key through the internet under http://www.siemens.com/automation/licence and

enter it in the operating area "Start-up", function (HSK) "Licences".

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

8081 %1 option(s) is/are activated that are not licensed by the license key

Parameters: %1 = Number of non-licensed options

Definitions: One ore more options were activated, that are not licensed by the license key entered.

Reaction: NC Start disable

Alarm display

Remedy: The unlicensed options included in the option screen can be licensed using a new License Key.

Licensing is described in the "Operator's Manual, Chapter: Licensing in SINUMERIK 802D sl".

Alternative: Cancel option

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

8082 A wrong license key was entered three times, Power On required before

next entry.

Definitions: The license key was entered wrongly at least three times. Before the next input, a new power ON is

required.

Reaction: NC Start disable

Alarm display

Remedy: Perform NCK-Power-ON and enter correct License Key.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

8100 [Channel %1: ] Block %2: function not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: - Impossible due to embargo regulations:

- 1. Synchronous actions: Writing of feed, override and axial offsets ($AA_VC, $AC_VC, $AA_OVR,

$AA_VC and $AA_OFF) from synchronous actions as well as Continuous Dressing can be pro-

grammed only once in a block.

- 2. Extended measurement: 'Cyclic measurement' (MEAC) and 'Measurement from synchronous

action' is not possible.

- 3. Axis interpolation: The number of axes interpolating with one another must not exceed 4 (this also

includes synchronous coupling of axes via synchronous actions "DO POS[X]=$A..." "DO

FA[X]=$A...").

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10203 [Channel %1: ] NC start without reference point (action=%2<ALNX>)

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: NC start has been activated in the MDI or AUTOMATIC mode and at least one axis that needs to be

referenced has not reached its reference point.

Reaction: Interface signals are set.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 40

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl