Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 88)

Overview of alarms 06/2009

NCK alarms

2-88

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: Max. nesting depth control structures (IF-ELSE-ENDIF, LOOP-ENDLOOP etc.) exceeded. At the

present time, the max. nesting depth is 8.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct part program. If necessary, move parts to a subroutine.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

12700 [Channel %1: ] Block %2 contour definition programming not allowed as

modal sub-programis active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the external language mode, a block is programmed with contour definition and a modal cycle is

active at the same time. Because of unclear address assignment (e.g. R = radius for contour definition

or return plane for drilling cycle) contour definition programming must not be used when a modal cycle

is active.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

12701 [Channel %1: ] Block %2 illegal interpolation type for contour definition

active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In one contour definition block, G01 is not active as interpolation function. In one contour definition

block, the linear interpolation always has to be selected with G01. G00, G02, G03, G33 etc. are not

permitted.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program. Program linear interpolation G01.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

12710 [Channel %1: ] Block %2 illegal language element in external language

mode

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed language element is not allowed or unknown in external language mode. Only the

language elements from Siemens mode which are used for subprogram calls (except for Lxx) and the

language constructs for program repetition with REPEAT (UNTIL) are allowed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Check that the language command is available in Siemens mode. Switch to Siemens mode with G290.

Program the command in the next block and switch back to the external language mode in the follow-

ing block.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

12720 [Channel %1: ] Block %2 program number for macro call (G65/G66)

missing

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 88

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl