Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 231)

Cycle alarms

06/2009 Overview of alarms

2-231

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61301 [Channel %1: ] Block %2: Probe not switching

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring distance was completely traversed but no switching signal was generated at the mea-

suring input.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: -Check measuring input.

-Check measuring distance.

-Probe defective.

61302 [Channel %1: ] Block %2: Probe - collision

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring probe collided with an obstacle when being positioned.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: ? Check spigot diameter (may be too small)

? Check measuring distance (may be to long)

61303 [Channel %1: ] Block %2: Safety margin exceeded

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring result differs greatly from the specified value.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: -Check setpoint value.

-Increase parameter _TSA.

61304 [Channel %1: ] Block %2: Allowance

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61305 [Channel %1: ] Block %2: Dimension too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 231

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl