Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 272)

Overview of alarms 06/2009

Cycle alarms

2-272

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

62312 [Channel %1: ] Block %2: probe is not perpendicular to plane!

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions:

Reaction: Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

62313 [Channel %1: ] Block %2: The number of lines per page _PROTFORM[0]

is incorrect and is automatically adjusted.

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycle: CYCLE106.

Remedy: Check _PROTFORM[0] in the program.

62314 [Channel %1: ] Block %2: Traverse path limitation via software end

position, collision detection activated, continue with NC START / cancel

with RESET.

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE977

Remedy: Position the workpiece to be measured further away from the software end positions.

62315 [Channel %1: ] Block %2: Overwrite swivel data record TCARR = %4, yes

-> NC start, no -> reset

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE996

Remedy:

62316 [Channel %1: ] Block %2: Overwrite TRAORIdata, yes -> NC start, no ->

reset

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE996

Remedy:

62317 [Channel %1: ] Block %2: Tolerance of the linear vector %4 exceeded

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE996

Remedy:

62318 [Channel %1: ] Block %2: Tolerance of the rotary axis vector %4

exceeded

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE996

Remedy:

62500 [Channel %1: ] Block %2: GWPS has been limited

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE446

Remedy: Check the limit value for GWPS and program a lower value in the NC program if necessary

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 272

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl