Siemens SINUMERIK 802D sl Návod k obsluze stáhnout pdf (Strana 209)

Cycle alarms

06/2009 Overview of alarms

2-209

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61176 [Channel %1: ] Block %2: text length _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The text length in the engraving cycle is too short. This means that the text for engraving is longer than

the specified text length.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter longer text length

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61177 [Channel %1: ] Block %2: polar text length > 360 degrees

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter shorter text length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61178 [Channel %1: ] Block %2: code page not present

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified code page is not supported by the cycle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use code page 1252.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61179 [Channel %1: ] Block %2: character does not exist, no.: %4

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Character number

Definitions: The character entered in the text for engraving cannot be milled.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter another character.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61180 [Channel %1: ] Block %2: no name assigned to swivel data block,

although MD $MN_MM_NUM_TOOL_CARRIER > 1

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Although there are several swivel data blocks, no unique names have been assigned. Alarm triggered

by following cycles: CYCLE800.

Remedy: Assign unique names for swivel data blocks.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 339 340

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Návod k obsluze Strana 209

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl