Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 117)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-117

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14017 Channel %1 block %2 syntax error when calling the subroutine via M

function

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When calling M code subroutine with parameter transfer, an illegal syntax was detected:

Address extension not programmed as a constant.

M function value not programmed as a constant.

Note:

If a parameter transfer has been programmed via MD 10718 M_NO_FCT_CYCLE_PAR for an M

function replacement, the following restriction applies to this M function: both the address extension

and the M function value must be programmed for replacement as constant.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change the programming of the M function.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14018 Channel %1 block %2 parts program command %3 not executable

(protection level setpoint value / actual value: %4)

Parameters: %1 = Channel number

%2 = Block number, Label

%3 = Programmed command

%4 = Protection level of the command

%5 = Current protection level

Definitions: A protection level assigned to the part program command %3 is logically higher (smaller value) than

the current access right or the command does not exist in the current control configuration.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program. The valid language commands for the associated system configuration are

described in the Siemens Programming Guide or the manufacturer’s documentation.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14020 Channel %1 block %2 wrong value or wrong number of parameters on

function or procedure call

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An illegal parameter value was specified in a function or procedure call.

An illegal number of actual parameters was programmed in a function or procedure call.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14021 Channel %1 block %2 wrong value or wrong number of parameters on

function or procedure call

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An illegal parameter value was specified in a function or procedure call.

An illegal number of actual parameters was programmed in a function or procedure call.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change part program.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 117

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 117

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl