Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 152)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-152

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14900 Channel %1 block %2 center point and end point programmed

simultaneously

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of the opening angle, the circle center point was programmed

together with the circle end point. This is too much information for the circle. Only one of the two points

is allowed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Select the programming variant for which the dimension can be reliably taken from the workpiece des-

ignation (avoidance of conversion errors).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14910 Channel %1 block %2 invalid angle of aperture for programmed circle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of the opening angle, a negative opening angle or an opening

angle greater than or equal to 360 degrees has been programmed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program opening angle within the allowed range of values between 0.0001 and 359.9999 [degrees].

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14920 Channel %1 block %2 intermediate point of circle incorrect

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of an intermediate point all 3 points (start, end and intermediate

points) are on a straight line and the intermediate point (programmed by means of interpolation param-

eters I, J, K) is not located between the start and end points.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Locate the position of the intermediate point with the parameters I, J and K in such a way that it actually

is located between the start and end points of the circle or do not make use of this type of circle pro-

gramming and instead program the circle with radius or opening angle or center point parameters.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

15030 Channel %1 block %2 different measurement system settings

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The INCH or METRIC instruction describes the system of measurement in which the data blocks have

been read from the control.

In order to prevent the incorrect interpretation of data intended for a particular system of measure-

ment, a data block is only accepted if the above instruction matches the active system of measure-

ment.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change the system of measurement or load a data block which matches the system of measurement.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 152

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl