
Overview of alarms 06/2007
NCK alarms/ISO alarms
2-74
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition
Remedy: The behavior is correct at narrow locations that cannot be machined with the active tool.
Modify part program.
Use tool with smaller radius if necessary.
Program Con-
tinuation:
Clear alarm with the Delete key or NC START.
10764 Channel %1 block %2 discontinuous path with active tool radius
compensation
Parameters: %1 = channel number
%2 = block number, label
Definitions: This alarm occurs when, with active tool radius compensation, the starting point used for calculating
the compensation is not identical to the end point of the preceding block.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
10765 Channel %1 block %2 3D tool radius compensation not possible
Parameters: %1 = channel number
%2 = block number, label
Definitions: This alarm occurs when an attempt is made to activate the 3D tool radius compensation even though
the option required for this is not fitted in the control.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: The option cannot be activated by altering machine data because the necessary code is not physically
available.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
10770 Channel %1 block %2 change of corner type due to change of orientation
with active tool radius compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The type of a corner (inside or outside corner) depends not only on the programmed path but also on
the tool orientation. For this purpose, the programmed path is projected in the plane perpendicularly
to the actual tool orientation and the corner type is determined there. If a change in orientation is pro-
grammed (in one or several blocks) between two traversing blocks, resulting in the type of corner at
the end of the first traversing block being different from that at the start point of the second block, the
above error message is issued.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
10776 Channel %1 block%2 axis %3 must be geometry axis if tool radius
compensation is active
Parameters: %1 = channel number
%2 = block number, label
%3 = axis name
Komentáře k této Příručce