Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 230)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-230

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

20105 Channel %1: axes stopped by digitizer. Error code: %2

Parameters: %1 = Channel number

%2 = Error code of digitizing unit

Definitions: The digitizing unit has recognized an error in the communication and signaled this to the NC.

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Error code 1: Check cable connection

leading to the digitizing unit. Other error codes: See manual for digitizing unit.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

20106 Emergency stop set by the digitizer

Definitions: The digitizing unit has recognized a serious error and triggered an emergency stop. Cause: See dis-

play on the digitizing unit.

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: -

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

20108 Invalid data package received from the digitizer. Error codes %1, %2

Parameters: %1 = Error code of cyclic packet

%2 = Error code of out-of-band packet

Definitions: A data packet received by the digitizing unit could not be evaluated.

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Error code: 0, 0: Check cable connection

leading to the NC. Other error codes: e.g. wrong header, incorrect checksum (development documen-

tation).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

20109 Error in communication with the digitizer: status code of com-circuit: %1

Parameters: %1 = Status byte

Definitions: The circuit for serial communication with the digitizing unit signals a transmission error via its status

byte (framing error, parity etc.).

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Check connection cable leading to the

digitizing unit: In particular screening.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 230

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 230

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl