Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 127)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-127

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14130 Channel %1 block %2 too many initialization values given

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: On assigning an array by means of SET, more initialization values than existing array elements have

been specified in the program run.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce the number of initialization values.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14140 Channel %1 block %2 position programming without transformation not

allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Position information was programmed for an axis position but no transformation was active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14144 Channel %1 block %2 PTP movement not allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The PTP G code was programmed for a movement other than G0 or G1.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14146 Channel %1 block %2 CP or PTP movement without transformation not

allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The CP or PTP G code was programmed for a movement but no transformation was active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14157 Channel %1 block %2 illegal interpolation type with MOVT

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Linear or spline interpolation must be active with MOVT (G0, G1, ASPLINE, BSPLINE, CSPLINE).

Reaction: Correction block is reorganized.

Interpreter stop

Interface signals are set.

Alarm display.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 127

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl