Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 151)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-151

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14824 Channel %1 block %2 conflict with GWPS

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The functions of constant grinding wheel surface speed GWPS and constant cutting speed G96 S...

have been activated at the same time for a spindle.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14830 Channel %1 block %2 wrong feed type selected

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: G97 has been programmed in the displayed block although G96 was not (or G97 already) active pre-

viously.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove G97 from the displayed block and program the correct feed type (G93, G94, G95 or G96) for

the machining section which follows.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14840 Channel %1 block %2 incorrect value range for constant cutting speed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed cutting speed is not within the input range

Input range metric:0.01 to 9,999.99 [m/min]

Input range inch:0.1 to 99,999.99 [inch/min].

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program cutting speed under address S within the permissible range of values.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14850 Channel %1 block %2 changing the reference axis for a constant cutting

speed not allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The attempt was made via the SCC[AX] instruction to change the reference

axis for a constant cutting speed.

This is not allowed if the indicated axis is no geometry axis.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Please inform authorized personnel/service.

When programming SCC[AX] indicate a geometry axis known in the channel.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 151

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl