Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 197)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-197

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

16961 Channel %1 action %2<ALNX> prohibited during syntax check.

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: The function (2nd parameter) must not be activated during the syntax check.

Comment: The syntax check is served by the following PI services:

_N_CHKSEL _N_CHKRUN _N_CHKABO

Reaction: Alarm display.

Remedy: Wait for the end of the syntax check, or

Cancel the syntax check with reset, or

Cancel the syntax check with PI _N_CHKABO.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16962 Channel %1 NCK computing time reduced, start is not allowed.

Parameters: %1 = Channel number

Definitions: The computing time available to the NCK has been reduced, starts have therefore been locked. The

computer performance is inadequate for smooth program execution. The computing time of the NCK

may have been reduced by the HMI because of an HMI part program simulation.

Reaction: Alarm display.

Remedy: Wait for the simulation to end or press RESET in any channel.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

17000 Channel %1 block %2 maximum number of symbols exceeded

Parameters: %1 = channel number

%2 = block number, label

Definitions: The maximum number of symbols defined by machine data 28020 MM_NUM_LUD_NAMES_TOTAL

has been exceeded.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

• Edit machine data

• Reduce the number of symbols (variables, subroutines, parameters)

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

17001 Channel %1 block %2 no memory left for tool/magazine data

Parameters: %1 = channel number

%2 = block number, label

Definitions: The quantity of tool data in the NC is limited.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Delete any unnecessary tools.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17010 Channel %1 block %2 no memory left

Parameters: %1 = channel number

%2 = block number, label

Definitions: When executing/reading files from the active working memory, it was found that there is not enough

memory space (e.g. when creating tool offset memory).

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Make more memory available to the data management system for subroutine calls and tool offsets

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 197

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 197

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl