Siemens SINUMERIK 802D sl Specifikace Strana 180

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 392
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 179
Overview of alarms 06/2007
NCK alarms/ISO alarms
2-180
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition
16785 Channel %1 block %2 identical spindles/axes %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: A coupling has been switched on in which the following spindle/axis is identical to the master spin-
dle/axis.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Configure link accordingly in MD (channel MD: COUPLE_AXIS_n)
- or modify part program.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
16786 Channel %1 block %2 coupling to master spindle %3 already exists
Parameters: %1 = channel number
%2 = block number, label
%3 = master spindle number
Definitions: An attempt has been made to activate a coupling with a slave spindle that is already configured in an
active coupling with another master spindle. The number of master spindles is restricted to one with
the synchronous spindle function. The existing active master spindle is displayed as the last alarm
parameter.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The existing coupling must be separated before the new coupling is activated. The ELG function must
be used if a coupling with several master spindles / axes is required.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
16787 Channel %1 block %2 coupling parameter not changeable
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified coupling is write-protected. Therefore, the coupling parameters cannot be modified.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Remove write protection. Channel MD: COUPLE_AXIS_IS_WRITE_PROT
- or modify part program.
Program Con-
tinuation:
Clear alarm with the RESET key. Restart part program
16788 Channel %1 block %2 cyclic coupling
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A coupling has been switched on which results in a cyclic coupling, allowance being made for further
couplings. This cyclic coupling cannot be uniquely computed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
- Configure link accordingly in MD (channel MD: 21300 COUPLE_AXIS_n)
- or modify part program.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
Zobrazit stránku 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 391 392

Komentáře k této Příručce

Žádné komentáře