Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 300)

Overview of alarms 06/2007

Cycle alarms

2-300

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61265 Channel %1 block %2: Too many restrictions, use rectangular pocket

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling a maximum of only 3 sides can be delimited.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use pocket cycle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61266 Channel %1 Block %2: Illegal machining direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the delimitations and the direction of machining do not match.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another direction of machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61267 Channel %1 Block %2: Plane infeed too large, residual corners remain

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the plane infeed must not exceed 85%.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61268 Channel %1 block %2: Illegal machining direction, residual corners are

left over.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the machining direction does not match the selected delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The machining direction must be selected to match the delimitations.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 300

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl