Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 177)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-177

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

16763 Channel %1 block %2 axis %3 programmed speed is illegal (zero or

negative)

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: A spindle speed (S value) was programmed with the value zero or with a negative value.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: The programmed spindle speed (S value) must be positive. Depending on the application case, the

value zero can be accepted (e.g. G25 S0).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16770 Channel %1 block %2 axis %3 no measuring system available

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: A function has been programmed for an axis that requires a measuring system. According to MD 30

200 NUM_ENCS, this machine axis does not have a measuring system.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Remove the relevant function (e.g. SPOS) from the part program or enter an existing measuring sys-

tem in MD 30 200 NUM_ENCS.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16771 Channel %1 following axis %2 overlaid movement not enabled

Parameters: %1 = channel number

%2 = axis name, spindle number

Definitions: No gear synchronization and no overlay movement can be executed because this is not enabled at

the VDI interface.

Reaction: Alarm display.

Remedy: Set the "Enable following axis overlay" VDI signal.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

16772 Channel %1 block %2 axis %3 is the slave axis, the coupling is being

opened

Parameters: %1 = channel number

%2 = block number, label

%3 = axis, spindle

Definitions: The axis is active as a following axis in a coupling. The coupling is opened in REF mode. The alarm

can be suppressed with machine data setting 11410 SUPPRESS_ALARM_MASK Bit29 = 1.

Reaction: Alarm display.

Remedy: The coupling is closed again when REF mode is ended.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

16773 Channel %1 axis %2 is the following axis. The axis/spindle disables of

leading axes %3 and %4 differ from one another.

Parameters: %1 = Channel number

%2 = Axis, spindle

%3 = Axis, spindle

%4 = Axis, spindle

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 177

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 177

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl